COOKWARE Paint Exterior – colorama coatings Properties and Areas of Use
-Tough, hard wearing flexible film, with excellent color and gloss retention.
-Superior chemical resistance and excellent water resistance.
– Can be easily over coated after long exposure periods
– Cures by stoving for (15-20) min. @ 200˚C.
-Used as a finish coat for exterior surfaces of cookware and home appliances.
COOKWARE Paint Exterior – colorama coatings Technical Coating Data @ 25 °C for mixed material
Finish High gloss, Semi-gloss and Matt
Color Range As per color card
Solids Volume 50 ± 2% Depending on color
Dry Film Thickness Range 25-100 µm
Theoretical Spreading Rate 10 m² / L @ 50 microns DFT
(loss factors will apply in practice)
Complete Cure (15-20) min. @ 200˚C
Pot Life Single Pack
Flash Point 28°C
Shelf Life 24 months (stored in a cool dry place)
Mixing Ratio by Weight Single Pack
VOC 387 g/L
Film Thickness and Spreading Rate:
Minimum Maximum Typical
Film thickness, dry (µm) 25 100 30
Film Thickness, wet (µm) 50 200 60
Theoretical Spreading Rate (m2/L) 20 5 16.67
Suitable Surfaces
-Surface must be dry and free from water, dirt, dust, oils and grease.
– Steel and non ferrous metals properly prepared and blast cleaned to ISO-Sa2½ or at leastcleaned using mechanical tool cleaning up to ST3.
Bare Steel:
Cleanliness: Blast – cleaning to Sa2 1/2 (ISO-8501-1:2007). Power tool cleaning to min. St3 (ISO 8501-1:2007) may be acceptable, subject to exposure conditions.
Other Surfaces:
For aluminum substrates , thorough washing and sweeping with a nonmetallic blast medium is required.
COOKWARE Paint Exterior – colorama coatings Application Conditions
Substrate temperature should be 10°C or above for application and a minimum of 3°C above the dew
point. Adequate dry air ventilation is recommended for optimum drying.
COOKWARE Paint Exterior – colorama coatings Application Information
Thinning should only take place after the two components have been thoroughly mixed.
Conventional Air Spraying
– Thin with 5-25% Paint Thinner Colorama TH998CW, as required.
– Tip size – 0.3 mm
– Tip pressure – 60 psi (0.4Mpa) approximately
Airless Spraying
– Thin with 0-20% Paint Thinner Colorama TH998CW, as required
– Tip size – 0.15-0.21 mm approximately
– Tip pressure – 2100 psi (15Mpa) approximately
Cleaning Thinner
Equipment should be cleaned immediately after use with Paint Thinner Colorama TH998CW.
Drying time:
Drying times are affected by air ventilation, temperature, film thickness and number of coats.
Complete Cure (15-20) min. @ 200˚C
Storage:
Keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition. Containers
must be kept tightly closed.
Handling:
Handle with care. Stir well before use.
Packing Size: 5 Kg , 18 Kg and 20 Kg
Summary Safety Information
– Avoid inhalation of spray mist and skin contact by the use of masks, gloves and other
personal protection. Eyes should be cautiously washed with water or proprietary wash, and
medical attention obtained. Skin should be thoroughly washed using a cleanser and soap and
water.
– Product is flammable
– No sparks or flames
– No smoking
earnesteen kettler –
earnesteen kettler