Product description
3D epoxy flooring – Floor coatings New innovative flooring systems achieving the same protection of epoxy but in beautiful seamless 3D shapes.
Properties and Areas of Use
– Tough hard wearing and flexible film.
-Excellent chemical resistant.
-Cures at low temperatures
Technical Coating Data @ 25 °C for mixed material
Finish High Gloss
Color Range As per color card
Solids Volume 99 ± 1%
Dry Film Thickness Range 100-500 µm
Theoretical Spreading Rate 10 m² / L @ 100 microns DFT
(loss factors will apply in practice)
Surface Dry 2 hours
Recoat Interval 12 hours minimum
10 days Maximum.
Complete Cure 7 days
Pot Life 45 min.
Flash Point > 100ºc
Shelf Life 12 months (stored in a cool dry place)
Mixing Ratio by Weight 3 Base component
1 Activator Component
VOC 0 g/l
Film Thickness and Spreading Rate:
Minimum Maximum Typical
Film thickness, dry (µm) 100 500 200
Film Thickness, wet(µm) 100 500 200
Theoretical Spreading Rate (m2/L) 10 2 5
Suitable Surfaces
Concrete free of contamination, dust and efflorescence, and properly prepared
Application Conditions
Substrate temperature should be 10°C or above for application and during cure and a minimum of
3°C above the dew point. Adequate dry air ventilation is recommended for optimum drying.
Application Information
No thinner needed for dilution.
Brush and Roller
Recommended
Airless Spraying
– No thinner needed
-Tip size – 0.58-.79 mm approximately
-Tip pressure – 2100 psi (15Mpa) approximately
Cleaning Thinner
Equipment should be cleaned immediately after use with Paint Thinner Colorama TH907E
Drying time:
Drying times are affected by air ventilation, temperature, film thickness and number of coats.
Substrate Temp. 10° C 25° C 40° C
Surface Dry 4 h 2 h 1 h
Through Dry 12 h 8 h 6 h
Dry to recoat, minimum 16 h 12 h 10 h
The given data serve as guideline only. The actual drying time differs according to film thickness,
ventilation, humidity and underlying paint system.
Storage:
Keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition. Containers
must be kept tightly closed.
Paint System:
- 3D Primer
3D Basecoat
3D Poster
3D Topcoat
Handling:
Handle with care. Stir well before use.
Packing Size: 5 L & 18 L
Summary Safety Information
– Avoid inhalation of spray mist and skin contact by the use of masks, gloves and other
personal protection. Eyes should be cautiously washed with water or proprietary wash, and
medical attention obtained. Skin should be thoroughly washed using a cleanser and soap and
water.
-Product is flammable
-No sparks or flames
-No smoking
Reviews
There are no reviews yet.