3D TOPCOAT – 3D Flooring – Floor Coatings A solvent free two pack polyamine cured epoxy clear coat designed to be used as a finish coat in the fields of water tank lining, steel structures, anti-chemicals flooring, fuel tank lining and crude oil tank lining and as an adhesive for wood
Properties and Areas of Use
– Tough hard wearing film
-Excellent chemical resistance
-Excellent water resistance
-Suitable for heavy duty floors of, for example, Warehouses, Factories, hangers, manufacturing plants, Garages ….etc.
Technical Coating Data @ 25 °C for mixed material
Color Range Transparent
Solids Volume 99 ± 1%
Dry Film Thickness Range 100-500 µm
Theoretical Spreading Rate 5 m² / L @ 200 microns DFT
(loss factors will apply in practice)
Surface Dry 6 hours
Recoat Interval 16 hours minimum
Complete Cure 7 days
Pot Life 1 hours
Flash Point >100°C
Shelf Life 12 months (stored in a cool dry place)
Mixing Ratio by Weight 5 Base component
3 Activator Component
Film Thickness and Spreading Rate:
Minimum Maximum Typical
Film thickness, dry (µm) 100 500 200
Film Thickness, wet(µm) 100 500 200
Theoretical Spreading Rate (m2/L) 10 2 5
-Suitable for concrete floors and marine decks
-Steel marine decks must be sand blasted to SIS-Sa 21/2 minimum
-Concrete surface prepared by using dust free captive blasting units, grinding equipment, sand blasting or high pressure water jetting
-This is critical for achieving the right surface profile prior to paint application.
Substrate temperature should be 10°C or above for application and during cure and a minimum of
3°C above the dew point. Adequate dry air ventilation is recommended for optimum drying.
Component A ( base ) must be thoroughly mixed before adding components B & C.
Brush and Roller
Stiff nylon brush or spiked roller.
Equipment should be cleaned immediately after use with Paint Thinner Colorama TH907EP.
Drying times are affected by air ventilation, temperature, film thickness and number of coats.
Substrate Temp. 10° C 25° C 40° C
Surface Dry 10 6 4
Through Dry 16 12 8
Dry to recoat, minimum 24 16 12
The given data serve as guideline only. The actual drying time differs according to film thickness,
ventilation, humidity and underlying paint system.
Typical paint system:
- 3D Primer
Keep the containers in a dry, cool, well ventilated space and away from source of heat and ignition. Containers must be kept tightly closed.
Handle with care. Stir well before use.
Packing Size: 5 L & 18 L
Summary Safety Information
-Avoid inhalation of spray mist and skin contact by the use of masks, gloves and other personal protection. Eyes should be cautiously washed with water or proprietary wash, and medical attention obtained. Skin should be thoroughly washed using a cleanser and soap and
-Product is flammable
-No sparks or flames
3D TOPCOAT – 3D Flooring – Floor Coatings